Nissan Versa (N17): Blower motor

Nissan Versa 2nd generation (N17) Service Manual / Ventilation, heater & air conditioner / Ventilation system (VTL) / Blower motor

Exploded View

Exploded View

1. A/C unit assembly 2. Blower motor 3. Blower fan resistor

Removal and Installation

REMOVAL

  1. Disconnect the negative battery terminal. Refer to PG "Removal and Installation".
  2. Remove the lower knee protector (LH). Refer to IP "Exploded View".
  3. Remove the accelerator pedal assembly. Refer to ACC "Removal and Installation".
  4. Remove the brake pedal assembly. Refer to BR9 "Removal and Installation".
  5. Disconnect the harness connectors from the blower motor.
  6. Disconnect the harness connector from the thermo control amp.
  7. Remove the blower motor screw (A).
  8. Press the flange holding hook and turn blower motor counterclockwise.
  9. Remove the blower motor.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Precautions

Precautions

Other materials:

P0983 Shift solenoid D
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0983 Shift Solenoid D Control Circuit High The following diagnosis conditions are met, and the current monitor reading of the TCM line pressure solenoid val ...

Refrigerant pressure sensor
Removal and Installation CAUTION: Perform oil return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or oil is detected, do not perform oil return operation. Refer to HA "Perform Oil Return Operation". REMOVAL Use refrigerant ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0056