Nissan Versa (N17): Bluetooth control signal circuit

Nissan Versa 2nd generation (N17) Service Manual / Driver information & multimedia / Audio, visual & navigation system (AV) / Bluetooth control signal circuit

Diagnosis Procedure

Regarding Wiring Diagram information, refer to AV "Wiring Diagram".

1.CHECK CONTROL SIGNAL CIRCUIT CONTINUITY

1. Turn ignition switch OFF.

2. Disconnect Bluetooth control unit connector B33.

3. Check continuity between Bluetooth control unit connector B33 and ground.

Is the inspection result normal?

YES >> Replace Bluetooth control unit. Refer to AV "Removal and Installation".

NO >> Repair or replace harness or connectors.

Bluetooth voice signal circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to AV "Wiring Diagram". 1.CHECK BLUETOOTH VOICE SIGNAL CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect audio ...

Microphone signal circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to AV"Wiring Diagram". 1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNIT AND MICROPHONE 1. Turn ignition switch OFF. 2. Disco ...

Other materials:

Variable voltage control system (if so equipped)
CAUTION Do not ground accessories directly to the battery terminal. Doing so will bypass the variable voltage control system and the vehicle battery may not charge completely. Use electrical accessories with the engine running to avoid discharging the vehicle battery. Your v ...

Position switch
Removal and Installation REMOVAL Drain gear oil. Refer to TM, "Draining". Disconnect the harness connector (A) from position switch. Remove position switch from transaxle case. INSTALLATION Apply recommended sealant to threads of position switch.    &nbs ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0073