Description
The headlamps (both sides) do not turn ON in any combination switch (lighting and turn signal switch) setting.
Diagnosis Procedure
1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION
Check the combination switch (lighting and turn signal switch). Refer to BCS "Symptom Table" (with Intelligent Key) or BCS "Symptom Table" (without Intelligent Key).
Is the combination switch (lighting and turn signal switch) normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning part.
2.CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT
CONSULT DATA MONITOR

Is the item status normal?
YES >> GO TO 3.
NO >> Replace BCM. Refer to BCS "Removal and Installation" (with Intelligent Key) or BCS "Removal and Installation" (without Intelligent Key).
3.HEADLAMP (LO) CIRCUIT INSPECTION
Check the headlamp (LO) circuit. Refer to EXL "HEADLAMP SYSTEM : System Description".
Is the headlamp (LO) circuit normal?
YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation" (with Intelligent Key) or PCS "Removal and Installation" (without Intelligent Key).
NO >> Repair or replace the malfunctioning part.
Both side headlamps do not switch
to high beamDescription The headlamps (both sides) do not switch to high beam when the combination switch (lighting and turn signal switch) is in the HI or PASS setting. Diagnosis Procedure 1.COMBINATION ...

Description The parking, license plate and tail lamps do not turn ON in any combination switch (lighting and turn signal switch) position. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND ...
Push-button ignition switch (if so equipped)
WARNING
Do not operate the push-button ignition
switch while driving the vehicle except in
an emergency. (The engine will stop when
the ignition switch is pushed 3 consecutive
times in quick succession or the ignition
switch is pushed and held for more
than 2 seconds.) If the engine stops ...
Manual air conditioning system
MANUAL AIR CONDITIONING SYSTEM : System
Diagram
MANUAL AIR CONDITIONING SYSTEM : System
Description
The manual air conditioning system is controlled by a sequence of
functions from the front air control, BCM,
ECM, and IPDM E/R.
The fan speed of the front blower motor is change ...