Nissan Versa (N17): Rear power window switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Power window control system (PWC) / Rear power window switch

Component Function Check

1. CHECK FUNCTION

Check rear power window motor operation with rear power window switch.

Is the inspection result normal?

YES >> Inspection End.

NO >> Refer to PWC "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to PWC "Wiring Diagram".

1.CHECK REAR POWER WINDOW SWITCH INPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect rear power window switch connector.

3. Turn ignition switch ON.

4. Check voltage between rear power window switch harness connector and ground.Is the Is the Is the inspection result normal?

YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK REAR POWER WINDOW SWITCH CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect power window main switch connector.

3. Check continuity between power window main switch harness connector and rear power window switch harness connector.

4. Check continuity between power window main switch harness connector and ground.

Is the inspection result normal?

YES >> Replace power window main switch. Refer to PWC "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK REAR POWER WINDOW SWITCH

Check rear power window switch.

Refer to PWC "Component Inspection".

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> Replace rear power window switch. Refer to PWC "Removal and Installation".

Component Inspection

1.CHECK REAR POWER WINDOW SWITCH

1. Turn ignition switch OFF.

2. Disconnect rear power window switch connector.

3. Check rear power window switch terminals under the following conditions.

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace rear power window switch. Refer to PWC "Removal and Installation".

Front power window switch (passenger side)

Component Function Check 1. CHECK FUNCTION Check front power window motor RH operation with front power window switch RH. Is the inspection result normal? YES >> Inspection End. NO >> ...

Other materials:

Front wheel hub and knuckle
Inspection Check the axle and suspension parts for excessive play, wear, or damage. Shake each front wheel to check for excessive play as shown. FRONT WHEEL BEARING INSPECTION Move wheel hub and bearing assembly in the axial direction by hand. Make sure the axial end play is withi ...

Slip indicator lamp
Component Function Check 1.CHECK SLIP INDICATOR LAMP FUNCTION Check that slip indicator lamp in combination meter turns ON for approximately 2 seconds after ignition switch is turned ON. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to diagnosis procedure. ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0066