DTC DETECTION LOGIC
DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
P0744 | Torque converter clutch circuit intermittent | The torque converter slip speed is at or above
a set value (40 rpm + (Vehicle speed / 2) continuously
for 30 seconds or more under the following
diagnosis conditions: - Diagnosis conditions - Selector lever: "D" position - Accelerator pedal position: 1.0/8 or more - Vehicle speed: 10 km/h (6 MPH) or more - Engine speed: 450 rpm or more - CVT fluid temperature: 20C (68F) ≤ CVT fluid temperature ≤ 180C (356F) - Lockup command is being given (except for slip lockup). - LU PRS: More than 0.2 MPa - TCM power supply voltage: More than 11 V |
- Torque converter clutch solenoid valve - Control valve assembly - Torque converter |
DTC CONFIRMATION PROCEDURE
CAUTION: Be careful of the driving speed.
1.PREPARATION BEFORE OPERATION 1
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.PREPARATION BEFORE OPERATION 2
With CONSULT
FLUID TEMP : 20C (68F) or more
With GST
NOTE: When the ambient temperature is 20C (68F), the CVT fluid usually increases to 50 to 80C (122 to 176F) with driving in an urban area for approximately 10 minutes.
Is the CVT fluid 20C (68F) or more?
YES >> GO TO 3.
NO >> 1. Warm the transaxle. 2. GO TO 3.
3.CHECK DTC DETECTION
Selector lever : "D" position
Accelerator pedal position : 1.0/8 or more
Vehicle speed : 40 km/h (25 MPH) or more
3. Stop the vehicle.
4. Check the first trip DTC.
Is "P0744" detected?
YES >> Go to TM "Diagnosis Procedure".
NO >> INSPECTION END
1.CHECK LINE PRESSURE
Perform line pressure test. Refer to TM "Work Procedure".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunction items.
2.CHECK TORQUE CONVERTER CLUTCH SOLENOID VALVE
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunction items.
3.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
Is the inspection result normal?
YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".
NO >> Repair or replace the malfunction items.
Component Inspection (Torque Converter Clutch Solenoid Valve)
1.CHECK TORQUE CONVERTER CLUTCH SOLENOID VALVE
Check resistance between CVT unit connector terminal and ground.
Is the inspection result normal?
YES >> INSPECTION END
NO >> There is a malfunction of torque converter clutch solenoid valve. Replace transaxle assembly.
Refer to TM "Removal and Installation".
Evaporator
Removal and Installation
REMOVAL
Remove A/C unit assembly. Refer to HA "Removal and Installation".
Disassemble A/C unit assembly and the evaporator assembly.
Remove thermo control amp. from evaporator assembly.
CAUTION:
If reusing the evaporator, mark the location of the the ...
Trunk lid striker
TRUNK LID STRIKER : Removal and Installation
REMOVAL
1. Remove trunk rear plate. Refer to INT "TRUNK REAR PLATE : Removal and
Installation".
2. Remove trunk lid opener cable bolt (A) and trunk lid striker bolts
(B).
3. Remove trunk lid striker (1), disconnect trunk lid opener cabl ...