Nissan Versa (N17): B26F3 Starter control relay

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B26F3 Starter control relay

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC B26F3 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS "DTC Logic".
  • If DTC B26F3 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS"DTC Logic".

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press push-button ignition switch under the following conditions to start engine.

  • Selector lever: In the P position
  • Brake pedal: Not depressed

2. Wait 2 seconds after engine started.

3. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK DTC OF IPDM E/R

Check DTC in Self Diagnostic Result mode of IPDM E/R using CONSULT.

Is DTC detected?

YES >> Perform the diagnosis procedure related to the detected DTC. Refer to PCS "DTC Index".

NO >> GO TO 2.

2.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

B260F Engine status

Description BCM receives the engine status signal from ECM via CAN communication. ...

Other materials:

Exhaust system
Exploded View 1. Heated oxygen sensor 2 2. Catalyst cover (upper) 3. Seal bearing 4. Catalyst cover (lower) 5. Spring 6. Spring 7. Mounting rubber 8. Main muffler 9. Ring gasket 10. Center muffler 11. Mounting rubber 12. Seal bearing 13. Exhaust front tube Removal and Installation WARNIN ...

CSC (Concentric slave cylinder)
Exploded View 1. Transaxle assembly 2. CSC (concentric slave cylinder) Removal and Installation CAUTION: Do not reuse CSC (concentric slave cylinder). CSC slides back to the original position every time when removing transaxle assembly. At this time, dust on the sliding parts may ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0086