Nissan Versa (N17): Front power window switch (passenger side)

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Power window control system (PWC) / Front power window switch (passenger side)

Component Function Check

1. CHECK FUNCTION

Check front power window motor RH operation with front power window switch RH.

Is the inspection result normal?

YES >> Inspection End.

NO >> Refer to PWC "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to PWC "Wiring Diagram".

1.CHECK FRONT POWER WINDOW SWITCH RH INPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect front power window switch RH connector.

3. Turn ignition switch ON.

4. Check voltage between front power window switch RH harness connector and ground.

Is the inspection result normal?

YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK FRONT POWER WINDOW SWITCH RH CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect power window main switch connector.

3. Check continuity between power window main switch harness connector and front power window switch RH harness connector.

4. Check continuity between power window main switch harness connector and ground.

Is the inspection result normal?

YES >> Replace power window main switch. Refer to PWC "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK FRONT POWER WINDOW SWITCH RH

Check front power window switch RH.

Refer to PWC "Component Inspection".

Is the inspection result normal?

YES >> Check Intermittent incident. Refer to GI "Intermittent Incident".

NO >> Replace front power window switch RH. Refer to PWC "Removal and Installation".

Component Inspection

1.CHECK FRONT POWER WINDOW SWITCH RH

1. Turn ignition switch OFF.

2. Disconnect front power window switch RH connector.

3. Check front power window switch RH terminals under the following conditions.

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace front power window switch RH. Refer to PWC "Removal and Installation".

Power supply and ground circuit

Rear power window switch

Component Function Check 1. CHECK FUNCTION Check rear power window motor operation with rear power window switch. Is the inspection result normal? YES >> Inspection End. NO >> Refer ...

Other materials:

Rear oil seal
REAR OIL SEAL : Removal and Installation REMOVAL Remove transaxle assembly. Remove clutch cover and clutch disk (M/T models). Remove flywheel (M/T models) or drive plate (A/T or CVT models). Remove rear oil seal with a suitable tool. CAUTION: Be careful not to damage crankshaft an ...

Brake lining
BRAKE LINING : Inspection and Adjustment INSPECTION Brake Lining Remove plug from back plate. Refer to BR "Exploded View". Check brake lining wear thickness (A) from an inspection hole on back plate. Check using a scale necessary. (A) : Refer to BR "Rear Drum Brake&quo ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0068