Description
Detects trunk open/close condition.
Component Function Check
1.CHECK FUNCTION
With CONSULT
Check TRNK/HAT MNTR in Data Monitor mode with CONSULT.

Is the inspection result normal?
YES >> Trunk room lamp switch is OK.
NO >> Refer to DLK "Diagnosis Procedure".
Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".
1.CHECK TRUNK ROOM LAMP SWITCH INPUT SIGNAL

Is the inspection result normal?
YES >> GO TO 6
NO >> GO TO 2
2.CHECK TRUNK ROOM LAMP SWITCH CIRCUIT


Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace harness between BCM and trunk room lamp switch.
3.CHECK TRUNK ROOM LAMP SWITCH GROUND CIRCUIT
Check continuity between trunk room lamp switch connector and ground.

Is the inspection result normal?
YES >> GO TO 4
NO >> Repair or replace trunk room lamp switch ground circuit.
4.CHECK BCM OUTPUT SIGNAL

Is the inspection result normal?
YES >> GO TO 5
NO >> Replace BCM. Refer to BCS "Removal and Installation".
5.CHECK TRUNK ROOM LAMP SWITCH
Refer to DLK "Component Inspection".
Is the inspection result normal?
YES >> GO TO 6
NO >> Replace trunk room lamp switch.
6.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
>> Inspection End.
1.CHECK TRUNK ROOM LAMP SWITCH

Is the inspection result normal?
YES >> Inspection End.
NO >> Replace trunk room lamp switch.
SYMPTOM DIAGNOSIS
Clutch pedal
Exploded View
1. Clutch pedal 2. Pedal stopper rubber 3. Pedal pad
4. Clip 5. Clutch interlock switch
Removal and Installation
REMOVAL
Remove the instrument lower panel LH. Refer to IP, "Removal and
Installation".
Disconnect master cylinder rod end from clutch pedal.
D ...
P0705 Transmission range switch A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0705
Transmission Range Sensor
"A" Circuit Malfunction (PRNDL
input)
The following diagnosis conditions
are met and 2 or more position
signals are ON at the
...