DRUM BRAKE : Inspection
BRAKE LINING
Brake lining specifications : Refer to BR "Rear Drum Brake".
BRAKE DRUM
NOTE: Measurement area is the lining contact surface (center).
Brake lining specifications : Refer to BR "Rear Drum Brake".
WHEEL CYLINDER
DISC BRAKE : Inspection BRAKE PAD Check the brake pads and components for any excessive wear or damage. Repair or replace any component as necessary. Brake pad specifications : Refer to BR &quo ...
STEERING GEAR AND LINKAGE : Inspection STEERING GEAR Check gear housing and boots for looseness, damage and grease leakage. Check connection with steering column for looseness. STEERIN ...
Shift lock system
Component Function Check
1.CHECK SHIFT LOCK OPERATION (BRAKE PEDAL RELEASED)
Ignition switch ON.
Attempt to shift selector lever to any position other than "P" position
with brake pedal released.
Can the selector lever be shifted?
YES >> Go to TM "Diagnosis Procedure".
...
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition &n ...