Nissan Versa (N17): P0998 Shift solenoid F

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P0998 Shift solenoid F

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P0998 Shift solenoid F control circuit low The TCM low brake solenoid valve current monitor reading is 200 mA or less continuously for 480 msec or more under the following diagnosis conditions:

- Diagnosis conditions

- Solenoid valve output current: 750 mA or more

- GND short circuit diagnosis occurs in the solenoid valve drive circuit.

- TCM power supply voltage: More than 11 V

 - Harness or connector (Low brake solenoid valve circuit shorted to ground)

- Low brake solenoid valve

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Shift the selector lever to "D" position and wait for 5 seconds or more.
  3. Check the first trip DTC.

Is "P0998" detected?

YES >> Go to TM "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT

  1. Turn ignition switch OFF.
  2. Disconnect TCM connector and CVT unit connector.
  3. Check continuity between TCM harness connector terminal and ground. 

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace malfunctioning parts.

2.CHECK LOW BRAKE SOLENOID VALVE

Check low brake solenoid valve. Refer to TM "Component Inspection (Low Brake Solenoid Valve)".

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> Repair or replace malfunctioning parts.

Component Inspection (Low Brake Solenoid Valve)

1.CHECK LOW BRAKE SOLENOID VALVE

Check resistance between CVT unit connector terminal and ground.  

Is the inspection result normal?

YES >> INSPECTION END

NO >> There is a malfunction of low brake solenoid valve. Replace transaxle assembly. Refer to TM "Removal and Installation".

P0967 Pressure control solenoid B

P0999 Shift solenoid F

Other materials:

Shift lock system
SHIFT LOCK SYSTEM : Component Parts Location 1. Stop lamp switch 2. Shift lock release lever 3. Park position switch 4. Shift lock solenoid Component Function Stop lamp switch Stop lamp switch turns ON when brake pedal is depressed Shift lock release lever Ma ...

OFF Position warning does not operate
Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC indicated. 2.CHECK DTC WITH COMBINATION METER Check that DTC is not detected with combination meter ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0053