INSTRUMENT CENTER : Removal and Installation
REMOVAL
1. Remove the instrument lower center panel. Refer to IP "Removal and Installation".
2. Remove screws (A) and the inside key antenna (instrument center) (1).

INSTALLATION
Installation is in the reverse order of removal.
CONSOLE : Removal and Installation
REMOVAL
1. Remove the center console assembly. Refer to IP "Removal and Installation".
2. Remove clips (A) and the inside key antenna (console) (1).

INSTALLATION
Installation is in the reverse order of removal.
TRUNK ROOM : Removal and Installation
REMOVAL
Remove clips (A) and the inside key antenna (trunk room) (1).

INSTALLATION
Installation is in the reverse order of removal.
Door switchExploded View 1. Door switch 2. Door switch bolt Removal and Installation REMOVAL 1. Remove the door switch bolt (A). 2. Disconnect the harness connector and remove door switch (1). INST ...
Wiper and washer switch
Switch operation
Type A (if so equipped)
The windshield wiper and washer operates when
the ignition switch is in the ON position.
Push the lever down to operate the wiper at the
following speed:
Intermittent (INT) - intermittent operation
can be adjusted by turning the knob toward
...
Transaxle
Transaxle : cross-sectional view
1. Converter housing 2. Oil pump 3. Low clutch
4. Rear planetary gear 5. Low & reverse brake 6. Front planetary gear
7. Low one-way clutch 8. High clutch 9. Reverse clutch
10. 2-4 brake band (Brake band) 11. Band servo piston 12. Side cover
13. Output ...