Type A (if so equipped)
Lighting
Type B (if so equipped)
CAUTION
Use the headlights with the engine running to avoid discharging the vehicle battery.
Headlight beam select
Battery saver system
If the ignition switch is placed in the OFF position
while the headlight switch is in the
or
position, the headlights will
turn off after
a period of time.
CAUTION
Even though the battery saver feature automatically turns off the headlights after a period of time, you should turn the headlight switch to the OFF position when the engine is not running to avoid discharging the vehicle battery.
Type A (if so equipped)
The instrument brightness control operates when
the headlight control switch is in the
or
position.
Type A: Turn the control A to adjust the brightness of instrument panel lights when driving at night.
Type B: Press the control A to adjust the brightness of instrument panel lights when driving at night.
Type B (if so equipped)
Turn signal
Lane change signal
Move the lever up or down until the turn signal begins to flash, but the lever does not latch, and release the lever. The turn signal will automatically flash three times.
Choose the appropriate method to signal a lane change based on road and traffic conditions.
To turn the fog lights on, turn the headlight switch
to the position, then turn the fog
light
switch to the
position.
To turn the fog lights off, turn the fog light switch to the OFF position.
The headlights must be on and the low beams selected for the fog lights to operate. The fog lights automatically turn off when the high beam headlights are selected.
To defrost the rear window glass, start the engine and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to tur ...
To sound the horn, push the center pad area of the steering wheel. WARNING Do not disassemble the horn. Doing so could affect proper operation of the supplemental front air bag system. Tamperin ...
Blower fan resistor
Exploded View
1. A/C unit assembly 2. Blower motor 3. Blower fan resistor
Removal and Installation
REMOVAL
Remove instrument panel assembly. Refer to IP "Removal and
Installation".
Disconnect harness connector from the blower fan resistor.
Remove screws and blower fan res ...
Power door lock system symptoms
Symptom Table
DOOR LOCK/UNLOCK FUNCTION MALFUNCTION
NOTE:
Before performing the diagnosis in the following table, check "WORK
FLOW". Refer to DLK "Work
Flow".
Check that vehicle is under the condition shown in "Conditions of
vehicle" before starting diagnosis, and
check e ...