Diagnosis Procedure
NOTE: If low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for 0.2 seconds, wake-up operation for all transmitters is not complete.
Carry out transmitter wake-up operation. Refer to WT "Work Procedure".
1.CHECK BCM CONNECTOR
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation" or BCS "Removal and Installation".
NO >> Repair or replace damaged parts.
ID REGISTRATION CANNOT BE COMPLETED
Diagnosis Procedure
1.PERFORM ID REGISTRATION OF ALL TRANSMITTERS
Carry out ID registration of all transmitters. Refer to WT "Work Procedure".
Can ID registration of all transmitters be completed?
YES >> Inspection End.
NO >> Refer to BCS "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)" or BCS "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)".
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts.

PERIODIC MAINTENANCE
Low tire pressure warning lamp
does not turn offDiagnosis Procedure 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES > ...

Inspection ALUMINUM WHEEL Check tires for wear and improper inflation. Check wheels for deformation, cracks and other damage. If deformed, remove wheel and check wheel runout. a. Remove ...
General maintenance
During the normal day-to-day operation of the
vehicle, general maintenance should be performed
regularly as prescribed in this section. If
you detect any unusual sounds, vibrations or
smells, be sure to check for the cause or have a
NISSAN dealer do it promptly. In addition, it is
recommended ...
U0155 Lost communication (IPC)
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
U0155
Lost Communication With Instrument
Panel Cluster (IPC)
Control Module
When the ignition switch is ON,
TCM is unable to receive the
CAN communications ...