Nissan Versa (N17): Mirrors

Nissan Versa 2nd generation (N17) Owners Manual / Pre-driving checks and adjustments / Mirrors

Rearview mirror

Rearview mirror

The night position 1 reduces glare from the headlights of vehicles behind you at night.

Use the day position 2 when driving in daylight hours.

WARNING

Use the night position only when necessary, because it reduces rear view clarity.

Outside mirrors

WARNING

  • Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
  • Do not adjust the mirrors while driving.

    You could lose control of your vehicle and cause an accident.

Electric control type

Electric control type

The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position.

Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2.

Manual folding outside mirrors

Manual folding outside mirrors

Pull the outside mirror toward the door to fold it.

Sun visors

1. To block glare from the front, swing down the sun visor 1 . 2. To block glare from the side, remove the sun visor from the center mount and swing the visor to the side 2 . 3. Slide the ext ...

Control panel buttons - color screen with Navigation System (if so equipped)

WARNING Positioning of the heating or air conditioning controls and display controls should not be done while driving in order that full attention may be given to the driving operation. ...

Other materials:

System (power door lock system)
System Diagram System Description   DOOR LOCK FUNCTION The door lock and unlock switch (driver side) is built into power window main switch. The door lock and unlock switch (passenger side) is on door trim. Interlocked with the locking operation of door lock and unlock swit ...

Rear power window switch
Removal and Installation REMOVAL 1. Remove rear power window switch finisher (1) assembly using a suitable tool (A). Pawl 2. Disconnect the harness connector from the rear power window switch. 3. Separate rear power window switch (1) from rear power window switch finisher using a suitable ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0101