Nissan Versa (N17): Mode door cable

MODE DOOR CABLE : Removal and Installation

REMOVAL

  1. Remove A/C unit assembly. Refer to HA "Removal and Installation".
  2. Disconnect mode door cable from A/C control.
  3. Disconnect mode door cable from A/C unit assembly, and then remove mode door cable.

INSTALLATION

Installation is in the reverse order of removal.

MODE DOOR CABLE : Adjustment

  1. Remove A/C unit assembly. Refer to HA "Removal and Installation".
  2. Disconnect mode door cable (1) from clamp (A).
  3. Set mode dial to VENT position.
  4. Push main link (2) in the direction as shown, and then carefully pulling outer cable to A/C control side, and connect clamp.
  5. Operate mode dial to insure that inner cable moves smoothly.

MODE DOOR CABLE : Adjustment

CAUTION: When clamping the outer cable, do not move the inner cable.

Intake door cable

INTAKE DOOR CABLE : Removal and Installation REMOVAL Remove instrument panel assembly. Refer to IP "Removal and Installation". Disconnect intake door cable from A/C control. Disc ...

Air mix door cable

AIR MIX DOOR CABLE : Removal and Installation REMOVAL Remove foot duct (LH). Refer to VTL "FOOT DUCT : Removal and Installation". Disconnect air mix door cable from A/C control. ...

Other materials:

Car phone or CB radio
When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts. WARNING A cellular phone should not be used for any purpose while driving so ...

Parking/parking on hills
WARNING Do not stop or park the vehicle over flammable materials such as dry grass, waste paper or rags. They may ignite and cause a fire. Safe parking procedures require that both the parking brake be set and the transmission placed into P (Park) or in an appropriate gear for ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0062