Nissan Versa (N17): Normal operating condition

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Wiper & washer (WW) / Normal operating condition

Description

FRONT WIPER PROTECTION FUNCTION

IPDM E/R detects front wiper stop position by a front wiper stop position signal.

When a front wiper stop position signal is in the conditions listed below, IPDM E/R stops power supply to wiper after repeating a front wiper 10 seconds activation and 20 seconds stop.

NOTE: This operation status can be confirmed on the IPDM E/R "Data Monitor" that displays "BLOCK" for the item "WIP PROT" while the wiper is stopped.

REMOVAL AND INSTALLATION

FRONT WIPER

Exploded View

Exploded View

1. Wiper arm cap 2. Wiper arm (LH) 3. Wiper blade (LH) 4. Wiper refill (LH) 5. Wiper arm (RH) 6. Wiper blade (RH) 7. Wiper refill (RH) 8. Wiper drive assembly

Front wiper does not operate

Description The front wiper does not operate under any operation conditions. Diagnosis Procedure Regarding Wiring Diagram information, refer to WW "Wiring Diagram". 1. CHECK WIPER RELAY ...

Wiper arm

Other materials:

Drive belt
1. Water pump pulley 2. Generator pulley 3. Manual tensioner pulley 4. Air conditioner compressor pulley 5. Crankshaft pulley WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. 1. Visually inspect t ...

Brakes
If the brakes do not operate properly, have the brakes checked. It is recommended that you visit a NISSAN dealer for this service. Self-adjusting brakes Your vehicle is equipped with self-adjusting brakes. The front disc-type brakes self-adjust every time the brake pedal is applied. The rea ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.018