Nissan Versa (N17): P1612 Chain of ECM-IMMU

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / P1612 Chain of ECM-IMMU

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000.

    Refer to BCS "DTC Logic".

  • If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble diagnosis for DTC U1010.

    Refer to BCS "DTC Logic".           

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in Self Diagnostic Result mode of ENGINE using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

Does the engine start?

YES >> Inspection End.

NO >> GO TO 2.

2.REPLACE ECM

1. Replace ECM. Refer to EC "Removal and Installation".

2. Perform "ADDITIONAL SERVICE WHEN REPLACING ECM". Refer to EC "Work Procedure".

>> Inspection End.

Other materials:

Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and ...

Door check link
DOOR CHECK LINK : Removal and Installation REMOVAL Fully close the front door window. Remove front door finisher. Refer to INT "Removal and Installation". Remove front door speaker bolts. Disconnect harness connector from front door speaker and remove. Remove door check link ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.008