Nissan Versa (N17): SRS Air bag warning lamp does not turn on

Nissan Versa 2nd generation (N17) Service Manual / Restraints / SRS Airbag control system (SRC) / SRS Air bag warning lamp does not turn on

AIR BAG Warning Lamp Does Not Turn On

1.CHECK METER FUSE

Check the 10A fuse [No. 3, located in the fuse block (J/B)].

Is the fuse blown?

YES >> GO TO 2

NO >> GO TO 3

2.REPLACE METER FUSE AND CHECK AGAIN

Replace 10A fuse [No. 3, located in the fuse block (J/B)] and turn ignition switch ON.

Does the fuse blow again?

YES >> Replace fuse and harness.

NO >> Inspection End.

3.CHECK HARNESS CONNECTIONS BETWEEN AIR BAG DIAGNOSIS SENSOR UNIT AND COMBINATION METER

Inspect the harness and connectors between the air bag diagnosis sensor unit and the combination meter.

Do the harness or connectors have any visible damage?

YES >> Replace harness.

NO >> GO TO 4

4.CHECK COMBINATION METER

Disconnect the air bag diagnosis sensor unit harness connectors and turn ignition switch ON.

Does AIR BAG warning lamp turn on?

YES >> Replace the air bag diagnosis sensor unit. Refer to SR "Removal and Installation".

NO >> Replace the combination meter. Refer to MWI "Removal and Installation" (with Type A Meter) or MWI "Removal and Installation" (with Type B Meter).

B1209 - B1210 Collision detection

Description DTC B1209 - B1210 COLLISION DETECTION The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a frontal or side deployment of one or m ...

SRS Air bag warning lamp does not turn off

AIR BAG Warning Lamp Does Not Turn Off 1.CHECK CONDITION OF AIR BAG MODULE Inspect for any deployed air bag modules or seat belt pre-tensioners. Are any air bag modules or seat belt pre-tensioners ...

Other materials:

Seat belt retractor
SEAT BELT RETRACTOR : Removal and Installation REMOVAL CAUTION: Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least three minutes. Disconnect both the negative and positive battery cables, then wait at least three minutes. Refer to PG " ...

Fuel filler lid lock
FUEL FILLER LID LOCK : Removal and Installation REMOVAL 1. Fully open fuel filler lid. 2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation". 3. Release pawls (A) and remove fuel filler lid lock assembly (1) from opening. CAUTION: Be car ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0113