Nissan Versa (N17): The seat belt reminder warning continues sounding, or does not sound

Nissan Versa 2nd generation (N17) Service Manual / Driver information & multimedia / Warning chime system (WCS) / The seat belt reminder warning continues sounding, or does not sound

Description

  • Seat belt reminder warning does not sound.
  • Seat belt reminder warning sounds continuously.

Diagnosis Procedure

NOTE: To identify combination meter type, refer to MWI "Information" or MWI "Information".

1.CHECK SEAT BELT WARNING LAMP

1. Turn ignition switch ON.

2. Check operation of seat belt warning lamp in combination meter.

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation" (TYPE A) or MWI "Removal and Installation" (TYPE B).

NO >> GO TO 2.

2.CHECK SEAT BELT BUCKLE SWITCH (LH) SIGNAL CIRCUIT

Perform check for seat belt buckle switch (LH) signal circuit. Refer to WCS "TYPE A : Diagnosis Procedure" (TYPE A) or WCS "TYPE B : Diagnosis Procedure" (TYPE B).

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair harness or connector.

3.CHECK SEAT BELT BUCKLE SWITCH (LH)

Perform check for seat belt buckle switch (LH). Refer to WCS "TYPE A : Component Inspection" (TYPE A) or WCS "TYPE B : Component Inspection" (TYPE B).

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation" (TYPE A) or MWI "Removal and Installation" (TYPE B).

NO >> Replace seat belt buckle (LH). Refer to SB"SEAT BELT BUCKLE : Removal and Installation".

The parking brake release warning continues sounding, or does not sound

Description The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released. The parking brake warning buzzer does not sound at all even thou ...

The light reminder warning does not sound

Description Light reminder warning chime does not sound even though headlamps are illuminated. Diagnosis Procedure 1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION Check that the headlamp ...

Other materials:

Component parts
Component Parts Location 1 BCM (view with instrument panel removed) 2 Remote keyless entry receiver (view with instrument panel removed) 3 Transmitter 4 Combination meter (with type A) 5 Combination meter (with type B) Component Description Component parts Function ...

U1000 CAN COMM
DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by performing the Self Diagnostic Result procedure.       ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0066