Nissan Versa (N17): Trunk lid assembly

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid assembly

Trunk lid assembly : Removal and Installation

CAUTION:

  • Use two people when removing or installing trunk lid assembly due to its heavy weight.
  • Use protective tape or shop cloths to protect surrounding components from damage during removal and installation of trunk lid assembly.

REMOVAL

  1. Remove trunk lid finisher (if equipped). Refer to INT "Removal and Installation".
  2. Disconnect the harness connector from the license plate lamp. Refer to EXL "Removal and Installation".
  3. Remove harness clips from trunk lid assembly, and then pull out harness from trunk lid assembly.
  4. Remove the trunk lid hinge bolts on trunk lid side and the trunk lid assembly.

CAUTION: Use two people when removing or installing trunk lid, due to its heavy weight.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • After installation, perform trunk lid adjustment procedure. Refer to DLK "TRUNK LID ASSEMBLY : Adjustment".
  • After installation, check trunk lid open/close and lock/unlock operation.
  • Apply touch-up paint (body color) onto the heads of the trunk lid hinge bolts.

Trunk lid assembly : Adjustment

TRUNK LID ASSEMBLY : Adjustment

1. Trunk lid assembly 2. Trunk lid hinge 3. Trunk lid striker 4. Body side outer 5. Rear combination lamp 6. Rear bumper fascia

Check the clearance and surface height between trunk lid and each part by visual inspection and tactile feel.

If the clearance and surface height are out of specification, adjust them according to the adjustment procedure.

  1. Loosen trunk lid hinge bolts (trunk lid side).
  2. Remove trunk rear plate. Refer to INT "TRUNK REAR PLATE : Removal and Installation".
  3. Loosen trunk lid striker bolts.
  4. Lift up trunk lid approximately 100 - 150 mm (3.9 - 5.9 in) then close it lightly and check that it is engaged firmly with trunk lid closed.
  5. Check the clearance and surface height.
  6. Tighten trunk lid hinge and trunk lid striker.
  7. Install trunk rear plate. Refer to INT "TRUNK REAR PLATE : Removal and Installation".

TRUNK LID STRIKER ADJUSTMENT

Adjust trunk lid striker so that it becomes parallel with trunk lid lock insertion direction.

Door check link

DOOR CHECK LINK : Removal and Installation REMOVAL Fully close the rear door window. Remove rear door finisher. Refer to INT-15, "Removal and Installation". Remove rear door speak ...

Trunk lid striker

TRUNK LID STRIKER : Removal and Installation REMOVAL 1. Remove trunk rear plate. Refer to INT "TRUNK REAR PLATE : Removal and Installation". 2. Remove trunk lid opener cable bolt (A) ...

Other materials:

Power steering fluid
Check the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 32 to 86ºF (0 to 30ºC). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid ...

Noise, vibration and harshness (NVH) troubleshooting
NVH troubleshooting Chart Locate the area where noise occurs. Confirm the type of noise. Specify the operating condition of engine. Check specified noise source If necessary, repair or replace these parts. Location of noise Type of noise Operating condition of ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0066