Description
Performs operation method guide and warning with buzzer.
1.CHECK FUNCTION
With CONSULT
Is the inspection result normal?
YES >> Warning buzzer into combination meter is OK.
NO >> Refer to DLK "Diagnosis Procedure".
1.CHECK METER BUZZER CIRCUIT
Operate the hazard lights by turning ON the hazard warning switch.
Is the inspection result normal?
YES >> GO TO 2
NO >> Replace combination meter. Refer to MWI "Removal and Installation" (type B) or MWI "Removal and Installation" (type A).
2.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
>> Inspection End.
Horn functionDescription Perform answer-back for each operation with horn. ...

Description Perform answer-back for each operation with number of blinks. Component Function Check 1.CHECK FUNCTION Check hazard warning lamp ("FLASHER") in Active Test. Is the inspection resul ...
Transmission assembly
Exploded View
1. Transaxle assembly
A : For the tightening torque, refer to TM "Removal and Installation".
Removal and Installation
WARNING:
Do not open the radiator cap or drain plug when the engine is hot.
Hot liquid may spray out, causing
serious injury.
Perform the ...
VDC OFF Switch
Component Function Check
1.CHECK VDC OFF SWITCH OPERATION
Check that VDC OFF indicator lamp in combination meter turns ON/OFF when VDC
OFF switch is operated.
Is the inspection result normal?
YES >> Inspection End.
NO >> Proceed to diagnosis procedure. Refer to BRC "Diagnos ...