Nissan Versa (N17): Wiper drive assembly

Wiper drive assembly: Removal and Installation

EXPLODED VIEW

EXPLODED VIEW

1. Wiper arm cap 2. Wiper arm (LH) 3. Wiper blade (LH) 4. Wiper refill (LH) 5. Wiper arm (RH) 6. Wiper blade (RH) 7. Wiper refill (RH) 8. Wiper drive assembly

REMOVAL

1. Remove cowl top cover. Refer to EXT "Removal and Installation".

2. Disconnect the harness connector from the wiper motor.

3. Remove the wiper drive assembly bolts.

4. Remove wiper drive assembly from the vehicle.

INSTALLATION

Installation is in the reverse order of removal.

Wiper drive assembly : Disassembly and Assembly

EXPLODED VIEW

EXPLODED VIEW

1. Shaft seal 2. Wiper frame 3. Wiper linkage 1 4. Wiper linkage 2 5. Wiper motor assembly 6. Wiper motor assembly bracket

DISASSEMBLY

1. Remove wiper linkage 1 and wiper linkage 2 from the wiper frame.

CAUTION: Do not bend the linkage or damage the plastic part of the ball joint when removing the wiper linkage.

2. Remove wiper motor screws.

3. Remove the wiper motor from the wiper frame.

ASSEMBLY

1. Connect the harness connector to the wiper motor.

2. Operate wiper to move it to the auto stop position.

3. Disconnect the harness connector from the wiper motor.

4. Install wiper motor to wiper frame.

5. Install wiper linkage 1 to the wiper motor and the wiper frame.

6. Install wiper linkage 2 to the wiper frame.

CAUTION:

  • Do not drop wiper motor or cause it to come into contact with other parts.
  • Be careful of the grease condition at the wiper motor and wiper linkage joint (retainer). Apply multi−purpose grease or an equivalent if necessary.

Wiper refill

WIPER REFILL : Removal and Installation REMOVAL 1. Remove wiper blade from the wiper arm. Refer to WW "WIPER BLADE : Removal and Installation". 2. From portion (A) of wiper refill (1), ...

Washer tank

Exploded View 1. Washer tank inlet cap 2. Washer tank assembly Front Removal and Installation REMOVAL 1. Remove fender protector. Refer to EXT "Removal and Installation". 2. Di ...

Other materials:

Power supply and ground circuit
Diagnosis Procedure 1.CHECK GROUND CONNECTION Turn ignition switch OFF. Check ground connection E. Refer to Ground Inspection in GI, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace ground connection. 2.CHECK ECM G ...

Mode door cable
MODE DOOR CABLE : Removal and Installation REMOVAL Remove A/C unit assembly. Refer to HA "Removal and Installation". Disconnect mode door cable from A/C control. Disconnect mode door cable from A/C unit assembly, and then remove mode door cable. INSTALLATION Installation ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0083