Nissan Versa (N17): Inspection and adjustment

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Inspection and adjustment

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)

Additional service when replacing control unit (bcm) : Description

EFORE REPLACEMENT

When replacing BCM, save or print current vehicle specification with CONSULT configuration before replacement.

NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

AFTER REPLACEMENT

CAUTION:

  • When replacing BCM, you must perform "After Replace ECU" with CONSULT.
  • Complete the procedure of "After Replace ECU" in order.
  • If you set incorrect "After Replace ECU", incidents might occur.
  • Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
  • When replacing BCM, perform the system initialization (NATS).

Additional service when replacing control unit (BCM) : Work Procedure

1.SAVING VEHICLE SPECIFICATION

CONSULT

Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

>> GO TO 2.

2.REPLACE BCM

Replace BCM. Refer to BCS "Removal and Installation".

>> GO TO 3.

3.WRITING VEHICLE SPECIFICATION

CONSULT

  1. Enter "Re/Programming, Configuration".
  2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to DLK "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure".
  3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to DLK "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure".

>> GO TO 4.

4.INITIALIZE BCM (NATS)

Perform BCM initialization. (NATS)

>> Work End.

DTC/CIRCUIT DIAGNOSIS

Diagnosis and repair work flow

Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incide ...

Other materials:

Security systems (if so equipped)
Your vehicle has one type of security systems: NISSAN Vehicle Immobilizer System NISSAN vehicle immobilizer system The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for ex ...

Thermostat
Exploded View 1. Radiator hose (lower) 2. Water inlet 3. Rubber ring 4. Thermostat A. To radiator Removal and Installation WARNING: Do not remove the radiator cap when the engine is hot. Serious burns could occur from highpressure engine coolant escaping from the radiator. Wrap a thick cl ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0074