When replacing the TCM, perform the following work.
CHECK LOADING OF CALIBRATION DATA
CALIBRATION OF G SENSOR
CAUTION: When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and then replace TCM.
If the TCM is replaced in advance, perform "ADDITIONAL SERVICE WHEN REPLACING TRANSAXLE ASSEMBLY" after "G sensor calibration".
1.CHECK WORK CONTENTS
Replacing only the TCM>>GO TO 2.
Replacing the TCM after the transaxle assembly is replaced>>GO TO 2.
Replacing the transaxle assembly after the TCM is replaced>>GO TO 5.
2.LOADING OF CALIBRATION DATA
NOTE: Displayed approximately 4 - 5 seconds after the selector lever is moved to the "P" position.
Does the shift position indicator display "P"?
YES >> GO TO 3.
NO >> GO TO 4.
3.PERFORM G SENSOR CALIBRATION
Refer to TM "Work Procedure".
>> WORK END
4.DETECT MALFUNCTIONING ITEM
Check the following items:
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
5.PERFORM G SENSOR CALIBRATION
Refer to TM "Work Procedure".
>> Perform "ADDITIONAL SERVICE WHEN REPLACING TRANSAXLE ASSEMBLY" after "CALIBRATION OF G SENSOR". Refer to TM "Work Procedure".
Remote keyless entry system (if so equipped)
WARNING
Radio waves could adversely affect
electric medical equipment. Those who
use a pacemaker should contact the
electric medical equipment manufacturer
for the possible influences before
use.
The remote keyless entry key fob transmits
radio waves when the buttons are
pressed. ...
P0705 Transmission range switch A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0705
Transmission Range Sensor
"A" Circuit Malfunction (PRNDL
input)
The following diagnosis conditions
are met and 2 or more position
signals are ON at the
...