Toyota
Nissan Versa
 Sedan Service Manual
Electrical & power control » Body control system (BCS)
BCM (Body control module)

Removal and Installation

CAUTION: Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification.

Refer to BCS "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description".

REMOVAL

1. Disconnect the negative battery terminal. Refer to PG"Removal and Installation".

2. Remove instrument lower panel LH. Refer to IP "Removal and Installation".

3. Remove BCM screws (A) and pull out the BCM (B).

4. Disconnect the harness connectors from the BCM (B) and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Be sure to perform "WRITE CONFIGURATION" when replacing BCM. Refer to BCS "CONFIGURATION (BCM) : Work Procedure".
  • For Canada, be sure to perform the system initialization (NATS) when replacing BCM. Refer to BCS "CONFIGURATION (BCM) : Work Procedure".
  • When replacing BCM, if new BCM does not come with keyfobs attached, all existing keyfobs must be re-registered.
    More about «Body control system (BCS)»:

    Precautions

    System

    Diagnosis system (BCM)

    BCM

    Inspection and adjustment

    U1000 CAN Comm circuit

    U1010 Control unit (CAN)

    U0415 Vehicle speed

    B2562 Low voltage

    Power supply and ground circuit

    Combination switch input circuit

    Combination switch output circuit

    BCM (Body control module)

    Combination switch

    Precautions

    System

    BCM

    Inspection and adjustment

    U1000 CAN Comm

    U1010 Control unit (CAN)

    Power supply and ground circuit

    Combination switch input circuit

    Combination switch output circuit

    BCM (Body control module)

    Combination switch

    Nissan Versa Sedan Service Manual / Electrical & power control / Body control system (BCS) / BCM (Body control module)

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com