BRAKE DRUM : Inspection and Adjustment
INSPECTION
Appearance
Check surface of brake drum for uneven wear, cracks and serious damage. Replace it if necessary. Refer to BR "Removal and Installation".
Brake Drum Inner Diameter
Check inner diameter (B) of the brake drum.
(B) : Refer to BR "Rear Drum Brake".

ADJUSTMENT
Burnish contact surfaces between brake drum and brake lining according to the following procedure after refinishing or replacing brake drum, or if a soft pedal occurs at very low mileage.
CAUTION:
REMOVAL AND INSTALLATION
Brake liningBRAKE LINING : Inspection and Adjustment INSPECTION Brake Lining Remove plug from back plate. Refer to BR "Exploded View". Check brake lining wear thickness (A) from an inspection ho ...

Exploded View 1. Clevis pin 2. Brake pedal assembly 3. Brake pedal pad 4. Stop lamp switch 5. Clip 6. Snap pin 7. ASCD cancel switch (if equipped) NOTE: CVT and A/T brake pedal assemblies sh ...
Power outlets
Instrument panel
Console (if so equipped)
The power outlets are for powering electrical
accessories such as cellular telephones. The
outlets are rated at 12 volt, 120W (10A) maximum.
CAUTION
The outlet and plug may be hot during
or immediately after use.
Only certain power outlets ...
Before starting the engine
Make sure the area around the vehicle is
clear.
Check fluid levels such as engine oil, coolant,
brake and clutch fluid (if so equipped),
and windshield-washer fluid as frequently as
possible, or at least whenever you refuel.
Check that all windows and lights are clean.
Visually insp ...