Nissan Versa (N17): Brake pad

BRAKE PAD : Inspection and Adjustment

INSPECTION

Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary.

Wear thickness : Refer to BR "Front Disc Brake".

INSPECTION

ADJUSTMENT

Burnish contact surfaces between disc rotor and brake pads according to the following procedure after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage.

CAUTION:

  • Be careful of vehicle speed because the brake does not operate firmly/securely until pads and disc rotor are securely fitted.
  • Only perform this procedure under safe road and traffic conditions. Use extreme caution.
  1. Drive vehicle on straight, flat road.
  2. Depress brake pedal with the power to stop vehicle within 3 to 5 seconds until the vehicle stops.
  3. Drive without depressing brake for a few minutes to cool the brake.
  4. Repeat steps 1 to 3 until pad and disc rotor are securely fitted.

Disc rotor

DISC ROTOR : Inspection and Adjustment INSPECTION Appearance Check surface of disc rotor for uneven wear, cracks, and serious damage. Replace it if necessary. Refer to BR "DISC ROTOR : Insp ...

Other materials:

Additional service when replacing TCM
Description Always perform the following items when the TCM is replaced. LOADING OF THE CALIBRATION DATA The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform accur ...

System
System Diagram System Description AUDIO SYSTEM The audio system consists of the following components Audio unit Front door speakers Rear door speakers Steering wheel audio control switches USB interface Satellite antenna Antenna amp. Rod antenna When the audio system is ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0066