Nissan Versa

 Sedan Service Manual

Driver controls » Exterior lighting system (EXL) » Rear combination lamp
Bulb Replacement

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION:

• Disconnect the battery negative terminal or remove power circuit fuse while performing the operation.
• Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
• Do not leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.

STOP/TAIL LAMP BULB

Removal

1. Remove rear combination lamp. Refer to EXL "Removal and Installation".

2. Remove screws (A) and the bulb holder.

3. Rotate stop/tail lamp bulb counterclockwise and remove.

Installation

Installation is in the reverse order of removal.

CAUTION: After installing the bulb, install the back cover and the bulb socket securely for watertightness.

REAR TURN SIGNAL LAMP BULB

Removal

1. Remove rear combination lamp. Refer to EXL "Removal and Installation".

2. Remove screws (A) and the bulb holder.

3. Rotate rear turn signal lamp bulb counterclockwise and remove

Installation

Installation is in the reverse order of removal.

CAUTION: After installing the bulb, install the cover and the bulb socket securely for watertightness.

BACK-UP LAMP BULB

Removal

1. Remove rear combination lamp. Refer to EXL "Removal and Installation".

2. Remove screws (A) and the bulb holder.

3. Rotate back-up lamp bulb counterclockwise and remove.

Installation

Installation is in the reverse order of removal.

CAUTION: After installing the bulb, install the cover and the bulb socket securely for watertightness.

Removal and Installation

Bulb Replacement