Nissan Versa

 Sedan Service Manual

Maintenance (MA) » Chassis and body maintenance
Clutch fluid

CLUTCH FLUID : Inspection

FLUID LEAKAGE

• Check clutch line for cracks, deterioration or other damage. Replace any damaged parts.
• Check for fluid leakage by fully depressing clutch pedal while engine is running.

CAUTION: If leaks occur around connections, reinstall the lines or replace damaged parts, if necessary.

FLUID LEVEL

• Check that the fluid level in the reservoir tank is within the specified range, between the MAX and MIN lines as shown.
• Visually check for any clutch fluid leaks around the reservoir tank.
• Check the clutch system for any leaks if the fluid level is extremely low (lower than MIN).

CLUTCH FLUID : Draining

CAUTION: Do not spill clutch fluid onto painted surfaces. If fluid spills, wipe up immediately and wash the affected area with water.

1. Connect a transparent vinyl hose to air bleeder of bleeding connector (1).

2. Press the lock pin (1) into the bleeding connector (2), and maintain the position.

3. Slide clutch tube (1) for the specified distance (A) in the direction of the arrow ( ) as shown.

(2) : Bleeding connector

Dimension (A) : 5 mm (0.20 in)

CAUTION: Do not allow the clutch tube to disconnect from the bleeding connector.

4. Depress clutch pedal to gradually discharge clutch fluid.

CAUTION: Clutch tube is under hydraulic pressure; do not allow the clutch tube to disconnect from the bleeding connector.

CLUTCH FLUID : Refilling

CAUTION: Do not spill clutch fluid onto painted surfaces. If fluid spills, wipe up immediately and wash the affected area with water.

1. Check that there is no foreign material in reservoir tank and then fill with new clutch fluid.

CAUTION: Do not reuse drained clutch fluid.

2. Connect a transparent vinyl hose to air bleeder of bleeding connector (1).

3. Press the lock pin (1) into the bleeding connector (2), and maintain the position.

4. Slide clutch tube (1) for the specified distance (A) in the direction of the arrow ( ) as shown.

(2) : Bleeding connector

Dimension (A) : 5 mm (0.20 in)

5. Slowly depress clutch pedal to the full stroke position and then release the pedal.

CAUTION: Clutch tube is under hydraulic pressure; do not allow the clutch tube to disconnect from the bleeding connector.

6. Repeat step 5 at intervals of 2 or 3 seconds until new clutch fluid is discharged.

CAUTION: Monitor clutch fluid level in reservoir tank so as not to empty the tank.

7. Return clutch tube and lock pin in their original positions while clutch pedal is depressed.

8. Perform the air bleeding. Refer to CL "Air Bleeding".

Exhaust system

CVT Fluid

A/T Fluid

Clutch fluid

M/T Oil

Road wheel

Brake fluid level and leaks

Brake lines and cables

Brake fluid

Disc brake

Drum brake

Steering gear and linkage

Axle and suspension parts

Seat belt, buckles, retractors, anchors and adjusters