Nissan Versa (N17): Shift lock system

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Shift lock system

Component Function Check

1.CHECK SHIFT LOCK OPERATION (BRAKE PEDAL RELEASED)

  1. Ignition switch ON.
  2. Attempt to shift selector lever to any position other than Park with brake pedal released.

Can the selector lever be shifted?

YES >> Go to TM "Diagnosis Procedure".

NO >> GO TO 2.

2.CHECK SHIFT LOCK OPERATION (BRAKE PEDAL APPLIED)

Attempt to shift the selector lever to any position other than Park with brake pedal applied.

Can the selector lever be shifted?

YES >> Inspection End.

NO >> Go to TM "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK STOP LAMP SWITCH

  1. Ignition switch ON.
  2. Check voltage between stop lamp switch connector E13 terminal 4 and ground. 

Is the inspection result normal?

YES >> GO TO 2.

NO >> GO TO 4.

2.CHECK A/T SHIFT SELECTOR

Check voltage between A/T shift selector connector M37 terminal 6 and ground. 

Is the inspection result normal?

YES >> GO TO 3.

NO >> GO TO 5.

3.CHECK GROUND CIRCUIT

  1. Ignition switch OFF.
  2. Disconnect A/T shift selector connector.
  3. Check continuity between A/T shift selector connector M37 terminal 6 and ground. 

Is the inspection result normal?

YES >> Replace A/T shift selector. Refer to TM "Removal and Installation".

NO >> Repair or replace ground circuit.

4.CHECK STOP LAMP SWITCH POWER CIRCUIT

Check voltage between stop lamp switch connector E13 terminal 3 and ground. 

Is the inspection result normal?

YES >> Replace stop lamp switch.

NO >> Repair or replace power circuit.

5.CHECK A/T SHIFT SELECTOR POWER CIRCUIT

Check voltage between A/T shift selector connector M37 terminal 5 and ground.

Is the inspection result normal?

YES >> Replace A/T shift selector. Refer to TM "Removal and Installation".

NO >> Repair or replace power circuit.

System symptom

Symptom Table

The diagnosis item numbers show the sequence for inspection. Inspect in order from item 1.

CAUTION: If any malfunction occurs in the RE4F03C transmission, replace the transaxle assembly.

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Symptom Table

Shift position indicator circuit

Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift the selector lever. Check that the selector lever position and the shift position indicator o ...

A/T Fluid

Inspection FLUID LEAKAGE Check transaxle surrounding area (oil seal and plug etc.)for fluid leakage. If anything is found, repair or replace damaged parts and adjust A/ T fluid level. Ref ...

Other materials:

Doors
When the doors are locked using one of the following methods, the doors cannot be opened using the inside or outside door handles. The doors must be unlocked to open the doors. WARNING Before opening any door, always look for and avoid oncoming traffic. To help avoid risk of injury or de ...

U1117 Lost communication (ABS)
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U1117 Lost Communication With ABS When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ABS actuator control unit cont ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0089