Nissan Versa (N17): Brake pedal position switch

Component Function Check

1.CHECK BRAKE PEDAL POSITION SWITCH FUNCTION

With CONSULT

  1. Turn ignition switch ON.
  2. Select "BRAKE SW1" in "DATA MONITOR" mode of "ENGINE" using CONSULT.
  3. Check "BRAKE SW1" indication as per the following conditions. 

Without CONSULT

  1. Turn ignition switch ON.
  2. Check the voltage between ECM harness connector terminals as per the following. 

Is the inspection result normal?

YES >> INSPECTION END

NO >> Proceed to EC, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK BRAKE PEDAL POSITION SWITCH POWER SUPPLY

  1. Turn ignition switch OFF.
  2. Disconnect brake pedal position switch harness connector.
  3. Turn ignition switch ON.
  4. Check the voltage between brake pedal position switch harness connector and ground. 

Is the inspection result normal?

YES >> GO TO 2.

NO >> Perform the trouble diagnosis for power supply circuit.

2.CHECK BRAKE PEDAL POSITION SWITCH INPUT SIGNAL CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect ECM harness connector.
  3. Check the continuity between brake pedal position switch harness connector and ECM harness connector.
  4. Also check harness for short to ground and to power.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace error-detected parts.

3.CHECK BRAKE PEDAL POSITION SWITCH

Check the brake pedal position switch. Refer to EC, "Component Inspection (Brake Pedal Position Switch)"

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".

NO >> Replace brake pedal position switch. Refer to BR, "Exploded View".

Component Inspection (Brake Pedal Position Switch)

1.CHECK BRAKE PEDAL POSITION SWITCH-I

  1. Turn ignition switch OFF.
  2. Disconnect brake pedal position switch harness connector.
  3. Check the continuity between brake pedal position switch terminals as per the following conditions.

Is the inspection result normal?

YES >> INSPECTION END

NO >> GO TO 2.

2.CHECK BRAKE PEDAL POSITION SWITCH-II

  1. Adjust brake pedal position switch installation. Refer to BR, "Inspection and Adjustment".
  2. Check the continuity between brake pedal position switch terminals as per the following conditions. 

Is the inspection result normal?

YES >> INSPECTION END

NO >> Replace brake pedal position switch. Refer to BR, "Exploded View".

Clutch pedal position switch

Component Function Check 1.CHECK CLUTCH PEDAL POSITION SWITCH FUNCTION Turn ignition switch ON. Check the voltage between ECM harness connector and ground.  Is the inspection result ...

Other materials:

Preparation
Special Service Tools The actual shapes of KentMoore tools may differ from those of special service tools illustrated here. Tool number (KentMoore No.) Tool name Description KV10111100 (J37228) Seal cutter   Removing oil pan (lower and upper) etc. ...

P0720 Output speed sensor
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0720 Output Speed Sensor Circuit Under the following diagnosis conditions, the output speed sensor value is less than 100 rpm continuously for 5 seconds or ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0076