NOTE: "Start the engine and turn OFF the ignition switch after warm-up." This is defined as 1 trip.
1 TRIP DETECTION DIAGNOSIS
When initial malfunction is detected, TCM memorizes DTC. In these diagnoses, some illuminate MIL and some do not. Refer to TM, "DTC Index".
2 TRIP DETECTION DIAGNOSIS
When initial malfunction is detected, TCM memorizes DTC of the 1st trip. MIL does not light at this stage. <1 trip> If the same malfunction is detected again in next driving, TCM memorizes DTC. When DTC is memorized, MIL lights. <2 trip> "Trip" of the "2 trip detection diagnosis" indicates the driving mode that executes self-diagnosis during driving.
×: Check possible -: Check not possible
Item | DTC at the 1st trip | DTC | MIL | |||
Display at the 1st trip | Display at the 2nd trip | Display at the 1st trip | Display at the 2nd trip | Illumination at the 1st trip | Illumination at the 2nd trip | |
1 trip detection diagnosis (Refer to TM, "DTC Index") | - | - | × | - | × | - |
2 trip detection diagnosis (Refer to TM, "DTC Index") | × | - | - | × | - | × |
2 TRIP DETECTION DIAGNOSIS THAT ILLUMINATES MIL
Diagnosis description : malfunction indicator lamp (MIL)
RELATION BETWEEN DTC AT 1ST TRIP/DTC/MI AND DRIVING CONDITIONS (FOR 2 TRIP DETECTION DIAGNOSIS THAT ILLUMINATES MIL)
DTC is erased when 40 trips are satisfied.
COUNTER SYSTEM LIST
DRIVING CONDITION
Driving Pattern A
Driving pattern A is the driving condition that provides warm-up.
In specific, count-up is performed when all of the following conditions are satisfied.
NOTE:
Driving Pattern B
In specific, count-up is performed when all of the following conditions are satisfied.
NOTE:
TIME CHART
Lock-up control : system diagram Lock-up control : system description The torque converter clutch piston in the torque converter is engaged to eliminate torque converter slip to increa ...
APPLICATION ITEMS Diagnostic test mode Function Work Support This mode enables a technician to adjust some devices faster and more accurately. Self Diagnostic Resul ...
Transmission assembly
Exploded View
1. Transaxle assembly
A : For the tightening torque, refer to TM "Removal and Installation".
Removal and Installation
WARNING:
Do not open the radiator cap or drain plug when the engine is hot.
Hot liquid may spray out, causing
serious injury.
Perform the ...
Front suspension member
Exploded View
1. Front suspension member 2. Transverse link
Removal and Installation
REMOVAL
Remove the wheel and tire assemblies using power tool. Refer to WT
"Adjustment".
Remove transverse link. Refer to FSU-12, "Removal and Installation".
Remove steering o ...