Toyota
Nissan Versa
 Sedan Service Manual
Body exterior, doors, roof & vehicle security » Security control system (SEC) » B2604 Shift position
Diagnosis Procedure

Regarding Wiring Diagram information, refer to SEC "Wiring Diagram".

1.CHECK DTC OF TCM

Check DTC in Self Diagnostic Result mode of TCM using CONSULT.

Is DTC detected?

YES >> Perform the trouble diagnosis related to the detected DTC. Refer to TM "DTC Index".

NO >> GO TO 2.

2.CHECK FUSE

1. Turn power switch OFF.

2. Check that the following fuse in IPDM E/R is not blown.       

Is the inspection result normal?

YES >> GO TO 3.

NO >> Replace the blown fuse after repairing the cause of blowing.

3.CHECK TRANSMISSION RANGE SWITCH POWER SUPPLY

1. Disconnect transmission range switch connector.

2. Turn ignition switch ON.

3. Check voltage between transmission range switch harness connector and ground.       

Is the inspection result normal?

YES >> GO TO 5.

NO >> GO TO 4.

4.CHECK TRANSMISSION RANGE SWITCH POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect IPDM E/R connector.

3. Check continuity between transmission range switch harness connector and IPDM E/R harness connector.

Is the inspection result normal?

YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

NO >> Repair or replace harness.

5.CHECK BCM INPUT SIGNAL

1. Turn ignition switch OFF.

2. Reconnect transmission range switch connector.

3. Turn ignition switch ON.

4. Check voltage between BCM harness connector and ground.       

Is the inspection result normal?

YES >> GO TO 9.

NO >> GO TO 6.

6.CHECK BCM INPUT SIGNAL CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect transmission range switch connector.

3. Disconnect BCM connector.

4. Check continuity between transmission range switch harness connector and BCM harness connector.

5. Check continuity between transmission range switch harness connector and ground.

Is the inspection result normal?

YES >> GO TO 7.

NO >> Repair or replace harness.

7.CHECK TRANSMISSION RANGE SWITCH

Refer to SEC "Component Inspection".

Is the inspection result normal?

YES >> GO TO 8.

NO >> Replace transmission range switch.

8.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

9.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

>> Inspection End.

    More about «B2604 Shift position»:

    DTC Logic

    Diagnosis Procedure

    Component Inspection

    Nissan Versa Sedan Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B2604 Shift position / Diagnosis Procedure

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com