Toyota
Nissan Versa
 Sedan Service Manual
Body exterior, doors, roof & vehicle security » Security control system (SEC) » B210D Starter relay
Diagnosis Procedure

Regarding Wiring Diagram information, refer to SEC "Wiring Diagram".

1.CHECK STARTER RELAY POWER SUPPLY CIRCUIT

1. Turn ignition switch ON.

2. Check voltage between BCM harness connector and ground.

Is the inspection result normal?

YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK STARTER RELAY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect starter relay.

3. Disconnect BCM connector.

4. Check continuity between starter relay harness connector and BCM harness connector.

5. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal?

YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK STARTER RELAY

Refer to SEC "Component Inspection".

Is the inspection result normal?

YES >> GO TO 4.

NO >> Replace starter relay.

4.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent keys using CONSULT.

3. Perform DTC CONFIRMATION PROCEDURE for DTC B210D. Refer to SEC "DTC Logic".

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

    More about «B210D Starter relay»:

    DTC Logic

    Diagnosis Procedure

    Component Inspection

    Nissan Versa Sedan Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B210D Starter relay / Diagnosis Procedure

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com