Description
Detects trunk open/close condition.
Component Function Check
1.CHECK FUNCTION
With CONSULT
Check TRNK/HAT MNTR in Data Monitor mode with CONSULT.
Is the inspection result normal?
YES >> Trunk room lamp switch is OK.
NO >> Refer to DLK "Diagnosis Procedure".
Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".
1.CHECK TRUNK ROOM LAMP SWITCH INPUT SIGNAL
Is the inspection result normal?
YES >> GO TO 6
NO >> GO TO 2
2.CHECK TRUNK ROOM LAMP SWITCH CIRCUIT
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace harness between BCM and trunk room lamp switch.
3.CHECK TRUNK ROOM LAMP SWITCH GROUND CIRCUIT
Check continuity between trunk room lamp switch connector and ground.
Is the inspection result normal?
YES >> GO TO 4
NO >> Repair or replace trunk room lamp switch ground circuit.
4.CHECK BCM OUTPUT SIGNAL
Is the inspection result normal?
YES >> GO TO 5
NO >> Replace BCM. Refer to BCS "Removal and Installation".
5.CHECK TRUNK ROOM LAMP SWITCH
Refer to DLK "Component Inspection".
Is the inspection result normal?
YES >> GO TO 6
NO >> Replace trunk room lamp switch.
6.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
>> Inspection End.
1.CHECK TRUNK ROOM LAMP SWITCH
Is the inspection result normal?
YES >> Inspection End.
NO >> Replace trunk room lamp switch.
SYMPTOM DIAGNOSIS
Camshaft valve clearance
Inspection and Adjustment
INSPECTION
Perform inspection as follows after removal, replacement or installation of
camshaft or valverelated parts, or if
there are unusual engine conditions regarding valve clearance.
Remove rocker cover.
Measure the valve clearance with the following proced ...
Camshaft
Exploded View
1. Camshaft bracket (No. 2 to 5) 2. Camshaft bracket (No. 1) 3. Camshaft
sprocket (EXH)
4. Exhaust valve timing control solenoid
valve 5. Oring 6. Camshaft sprocket (INT)
7. Plug (EXH) 8. Washer (EXH) 9. Oil filter (for exhaust valve timing control
solenoid valve)
10. Cylinde ...