Nissan Versa (N17): Differential side oil seal

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Differential side oil seal

Exploded View

Exploded View

1. Transaxle assembly 2. Differential side oil seal (left side) 3. Differential side oil seal (right side) Front Genuine NISSAN CVT Fluid NS-3

Removal and Installation

NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

  1. Remove the front drive shaft from the transaxle assembly. Refer to FAX "Removal and Installation"
  2. Remove the differential side oil seal using suitable tool.

CAUTION: When removing the differential side oil seal, be careful not to scratch the oil seal mating surfaces of the transaxle case and converter housing.

INSTALLATION

  1. Drive the differential side oil seal into the transaxle case side (A) and converter housing side (B) using suitable tool to the specified dimension.

CAUTION:

  • Be careful not to scratch the lip of the differential side oil seal when press-fitting it.
  • Do not reuse differential side oil seal.
  • Apply Genuine NISSAN CVT Fluid NS-3 to the differential side oil seal lip and around the oil seal.

Removal and Installation

Dimension (C) : 1.8 +- 0.5 mm (0.071 +- 0.020 in).

Dimension (D) : 1.8 +- 0.5 mm (0.071 +- 0.020 in).

    2.   Install the front drive shaft. Refer to FAX "Removal and Installation".

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for CVT fluid leakage. Refer to TM "Inspection".

ADJUSTMENT AFTER INSTALLATION

Adjust the CVT fluid level. Refer to TM "Adjustment".

Output speed sensor

Exploded View 1. Transaxle assembly 2. Output speed sensor 3. O-ring Front Genuine NISSAN CVT Fluid NS-3 Removal and Installation REMOVAL Disconnect the harness connector from output s ...

Water hose

Exploded View 1. Hose clamp 2. Water hose A 3. Bracket 4. Heater thermostat 5. Water hose B 6. Water hose C 7. Water bypass pipe 8. Hose clamp 9. Heater hose 9. Water hose D A. Water outlet B. ...

Other materials:

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is discon ...

Oil pan
Exploded View 1. Transaxle assembly 2. Oil pan gasket 3. Magnet 4. Oil pan 5. Overflow tube 6. Drain plug gasket 7. Drain plug 8. Oil pan fitting bolt Removal and Installation REMOVAL Remove the drain plug and overflow tube, and then drain the ATF. WARNING: A/T fluid can splash ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0389