Exploded View
1. Door switch 2. Door switch bolt
Removal and Installation
REMOVAL
1. Remove the door switch bolt (A).
2. Disconnect the harness connector and remove door switch (1).
INSTALLATION
Installation is in the reverse order of removal.
TRUNK LID OPENER SWITCH
Removal and Installation
REMOVAL
1. Remove the trunk lid finisher. Refer to EXT "Removal and Installation".
2. Disconnect harness connector from the trunk lid opener switch.
3. Remove the trunk lid opener switch.
INSTALLATION
Installation is in the reverse order of removal.
FUEL FILLER LID LOCK : Removal and Installation REMOVAL 1. Fully open fuel filler lid. 2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation". ...
Brakes
If the brakes do not operate properly, have the
brakes checked. It is recommended that you visit
a NISSAN dealer for this service.
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes.
The front disc-type brakes self-adjust every time
the brake pedal is applied. The rea ...
P0712 Transmission fluid temperature
sensor A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0712
Transmission Fluid Temperature
Sensor "A" Circuit Low
Under the following diagnosis
conditions, the A/T fluid temperature
identified by TCM is
180C (3 ...