DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With CONSULT
Is DTC "C1606" detected?
YES >> Proceed to diagnosis procedure. Refer to STC "Diagnosis Procedure".
NO >> Inspection End.
1.CHECK EPS MOTOR
Check the EPS motor. Refer to STC "Component Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> EPS motor is malfunction. Replace steering column assembly. Refer to ST"Removal and Installation".
2.CHECK CONNECTOR
Is the inspection result normal?
YES >> Replace EPS control unit. Refer to STC, "Removal and Installation".
NO >> Repair or replace malfunctioning component.
Component Inspection
1.CHECK EPS MOTOR
Is the inspection result normal?
YES >> Inspection End.
NO >> EPS motor is malfunctioning. Replace steering column assembly. Refer to ST "Removal and Installation".
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ...
Remote keyless entry system (if so equipped)
WARNING
Radio waves could adversely affect
electric medical equipment. Those who
use a pacemaker should contact the
electric medical equipment manufacturer
for the possible influences before
use.
The remote keyless entry key fob transmits
radio waves when the buttons are
pressed. ...
Precautions
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT
PRE-TENSIONER", used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and ...