Nissan Versa

 Sedan Service Manual

Body exterior, doors, roof & vehicle security » Exterior (EXT)
Front bumper

Exploded View

1. Front bumper side bracket (RH) 2. Front bumper reinforcement 3. Front bumper energy absorber 4. Front bumper fascia finisher (RH) (If equipped) 5. Front bumper fascia 6. Fog lamp finisher (RH) (if equipped) 7. Tow cover 8. License plate bracket 9. Under cover 10. Fog lamp finisher (LH) (if equipped) 11. Front bumper fascia finisher (LH) (if equipped) 12. Front bumper side bracket (LH) 13. Front spoiler A. Spring nut B. Screw grommet Pawl

Removal and Installation

REMOVAL

CAUTION: Bumper fascia is made of resin. Do not apply strong force to it, and be careful to prevent contact with oil.

1. Open hood.

2. Remove front bumper fascia upper side clips (A).

3. Remove under cover. Refer to EXT "Removal and Installation".

4. Remove fender protector clips and screws to access bumper fascia screw. Refer to EXT "Removal and Installation".

5. Remove front bumper fascia screws (A) (LH/RH).

6. Remove front bumper fascia lower side clips and screws.

7. Pull front bumper fascia away as shown by the arrows in the illustration and then disengage front bumper fascia from front bumper side brackets (LH/RH).

: Pawl

CAUTION: When removing front bumper fascia, two people are required to avoid damaging.

8. Disconnect the harness connectors from the front fog lamps (LH/RH) (If equipped).

9. Remove front bumper fascia.

10. Remove the following parts after removing front bumper fascia.

• Front bumper side brackets (LH/RH)
• Fog lamp finishers (LH/RH) (If equipped)
• Fog lamps (LH/RH) (If equipped). Refer to EXL "Removal and Installation".
• Front grille. Refer to EXT "Removal and Installation".
• License plate bracket

11. Remove front bumper energy absorber.

12. Remove nuts and front bumper reinforcement.

INSTALLATION

Installation is in the reverse order of removal.

NOTE:

• The following table shows the specified values for checking normal installation specifications.
• Fitting adjustment cannot be performed.

Precautions

Squeak and rattle trouble diagnoses

Front bumper

Under cover

Rear bumper

Front grille

Cowl top

Fender protector

Roof side molding

Door outside molding

Trunk lid finisher

Door parting seal

Rear spoiler