Nissan Versa (N17): Ignition position warning function does not operate

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Ignition position warning function does not operate

Diagnosis Procedure

1.CHECK POWER DOOR LOCK OPERATION

Check power door lock operation.

Does door lock/unlock with driver side door lock knob and door key cylinder?

YES >> GO TO 2.

NO >> Refer to DLK "Diagnosis Procedure".

2.CHECK DOOR SWITCH

Check door switch.

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.REPLACE BCM

Replace BCM. Refer to BCS "Removal and Installation".

Confirm the operation after replacement.

Is the result normal?

YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI "Intermittent Incident".

Auto door lock operation does not operate

Diagnosis Procedure 1.CHECK AUTO LOCK SET SETTING IN WORK SUPPORT Select INTELLIGENT KEY of BCM using CONSULT. Select AUTO LOCK SET in WORK SUPPORT mode. Check AUTO LOCK SET setting in WORK ...

Other materials:

Calibration of G Sensor
Description TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed. Removal/installation or replacement of G sensor Replacement of TCM Work ...

NATS antenna AMP
Removal and Installation NOTE: If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELFDIAG RESULTS" on CONSULT screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY". Initialization is not necessary when only th ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0061