Nissan Versa

 Sedan Service Manual

Body exterior, doors, roof & vehicle security » Door & lock (DLK) » Hood lock bell crank
Inspection

NOTE: If the hood lock cable is bent or deformed, replace it.

1. Check that secondary latch (1) is properly engaged with secondary striker (2) with hood's own weight.

2. Check that primary latch (1) is securely engaged with primary striker (2) when hood is dropped with hood's own weight from approximately 200 mm (7.9 in) height.

3. While operating the hood lock/fuel filler release handle assembly, carefully check that the front end of hood is raised by approximately 20.0 mm (0.79 in). Also check that hood lock/fuel filler release handle assembly returns to the original position.

4. Check that hood lock/fuel filler release handle assembly operates at 49 N (5.0 kg-f, 11.0 lb) or below.

5. Install so that static closing force of the hood is 300 - 490 N (31.0 - 50.0 kg-f, 67.4 - 110.2 lb-f).

NOTE:

• Do not exert vertical force on right side and left side of hood lock.
• Do not press simultaneously both sides.

6. Check the hood lock lubrication condition. If necessary, apply a suitable multi-purpose grease to secondary latch (1) and hood lock assembly (2).

FRONT DOOR LOCK

Exploded View

1. Door key cylinder assembly (driver side) Outside handle escutcheon (passenger side) 2. Rear gasket 3. Outside handle bracket 4. Bolt 5. Door key cylinder rod (driver side) 6. Door lock assembly 7. Inside handle 8. Outside handle 9. Front gasket 10. Clip Pawl Front

Hood lock bell crank : Removal and Installation

Inspection