Toyota
Nissan Versa
 Sedan Service Manual
Transmission & driveline » Transaxle & transmission (TM) » Transaxle assembly
Inspection

INSPECTION AFTER INSTALLATION

  • Check the operation of the control linkage. Refer to TM, "Inspection".
  • Before starting engine, check oil/fluid levels including engine coolant and engine oil. If less than required quantity, fill to the specified level. Refer to MA, "Fluids and Lubricants".
  • Use procedure below to check for fuel leakage.
  • Turn ignition switch ON (with engine stopped). With fuel pressure applied to fuel piping, check for fuel leakage at connection points.
  • Start engine. With engine speed increased, check again for fuel leakage at connection points.
  • Run engine to check for unusual noise and vibration.

NOTE:If hydraulic pressure inside timing chain tensioner drops after removal and installation, slack in the guidemay generate a pounding noise during and just after engine start. However, this is normal. Noise will stopafter hydraulic pressure rises.

  • Warm up engine thoroughly to make sure there is no leakage of fuel, exhaust gas, or any oils/fluids includingengine oil and engine coolant.
  • Bleed air from passages in lines and hoses, such as in cooling system.
  • After cooling down engine, again check oil/fluid levels including engine oil and engine coolant. Refill to specifiedlevel, if necessary.
  • Summary of the inspection items: 

*Power steering fluid, brake fluid, etc.

    More about «Transaxle assembly»:

    Removal and Installation

    Inspection

    Nissan Versa Sedan Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Transaxle assembly / Inspection

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com