Diagnosis Procedure
1.CHECK ANTI KEY LOCK IN FUNCTI SETTING IN WORK SUPPORT
Refer to BCS "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Set On in ANTI KEY LOCK IN FUNCTI.
2.CHECK DOOR SWITCH
Check door switch.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.CHECK INSIDE KEY ANTENNA
Check inside key antenna.
Is the inspection result normal?
YES >> GO TO 4.
NO >> Repair or replace the malfunctioning parts.
4.CHECK UNLOCK SENSOR
Check unlock sensor.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 5.
NO >> Repair or replace the malfunctioning parts.
5.REPLACE BCM
Is the result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI "Intermittent Incident".
Diagnosis Procedure 1.CHECK HAZARD ANSWER BACK SETTING IN WORK SUPPORT Select INTELLIGENT KEY of BCM using CONSULT. Select HAZARD ANSWER BACK in WORK SUPPORT mode. Check the HAZARD ANSWER BAC ...
Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC ind ...
Brakes
If the brakes do not operate properly, have the
brakes checked. It is recommended that you visit
a NISSAN dealer for this service.
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes.
The front disc-type brakes self-adjust every time
the brake pedal is applied. The rea ...
P0890 TCM
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0890
Transmission Control Module
Power Relay Sense Circuit Low
Under the following diagnosis
conditions, the battery voltage
supplied to the TCM is less than
...