Nissan Versa (N17): Oil filter

Removal and Installation

REMOVAL

  1. Remove engine under cover.
  2. Drain engine oil.
  3. Remove oil filter using Tool (A).

  : Front

Tool number : KV10115801 (J38956)

OIL FILTER

WARNING:

Be careful not to get burned; engine and engine oil may be hot.

CAUTION:

  • When removing, prepare a shop cloth to absorb engine oil leaks and spills.
  • Do not spill engine oil on drive belt.
  • Completely wipe off any engine oil that spills on engine and vehicle.
  • Oil filter is provided with relief valve. Use Genuine NISSAN oil filter or equivalent.

INSTALLATIN

  1. Remove foreign materials adhering to the oil filter installation surface.
  2. Apply new engine oil to the oil seal contact surface of new oil filter.

OIL FILTER

    3.   Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A), or tighten to specification.

Oil filter : 17.7 N*m (1.8 kgm, 13 ftlb)

OIL FILTER

    4.   Refill engine with new engine oil.

    5.   Install engine under cover.

Inspection

INSPECTION AFTER INSTALLATION

  1. Check the engine oil level.
  2. Start the engine and ensure there are no engine oil leaks.
  3. Stop the engine and wait for 10 minutes.
  4. Check the engine oil level and adjust as necessary.

Engine oil

Inspection ENGINE OIL LEVEL Park vehicle on a level surface, wait 10 minutes before checking the engine oil level. Pull out oil level gauge and wipe it clean. Insert oil level gauge and ma ...

Oil pump

Exploded View 1. Rear oil seal 2. Oring 3. Oil pan (upper) 4. Oil pump chain tensioner (for oil pump drive chain) 5. Oil pump drive chain 6. Crankshaft key 7. Crankshaft sprocket 8. Oil pump s ...

Other materials:

Fuel-filler door
Opener operation The fuel-filler door release is located below the instrument panel. To open the fuel-filler door, pull the release. To lock, close the fuel-filler door securely. Fuel-filler cap WARNING Gasoline is extremely flammable and highly explosive under certain conditions. ...

P0731 1GR Incorrect ratio
Description This malfunction is detected when the A/T does not shift into 1GR position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc. DTC ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0115