
The night position 1 reduces glare from the headlights of vehicles behind you at night.
Use the day position 2 when driving in daylight hours.
WARNING
Use the night position only when necessary, because it reduces rear view clarity.
WARNING
You could lose control of your vehicle and cause an accident.
Electric control type

The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position.
Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2.
Manual folding outside mirrors

Pull the outside mirror toward the door to fold it.
Sun visors1. To block glare from the front, swing down the sun visor 1 . 2. To block glare from the side, remove the sun visor from the center mount and swing the visor to the side 2 . 3. Slide the ext ...

WARNING Positioning of the heating or air conditioning controls and display controls should not be done while driving in order that full attention may be given to the driving operation. ...
Evaporator
Removal and Installation
REMOVAL
Remove A/C unit assembly. Refer to HA "Removal and Installation".
Disassemble A/C unit assembly and the evaporator assembly.
Remove thermo control amp. from evaporator assembly.
CAUTION:
If reusing the evaporator, mark the location of the the ...
Hood lock
HOOD LOCK : Removal and Installation
REMOVAL
1. Remove hood lock assembly bolts and hood lock assembly.
2. Disconnect hood lock control cable assembly (2) from hood lock
assembly (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Be careful not to bend the cable ...