DTC Logic
DTC DETECTION LOGIC
DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
P0711 | Transmission Fluid Temperature Sensor "A" Circuit Range/ Performance | Under the following diagnosis
conditions, A/T fluid temperature
does not rise to 15C
(59F) after driving for a certain
period of time with the TCM-received
fluid temperature sensor
value between −40C (−40F)
and 14C (57.2F). - Diagnosis condition
|
A/T fluid temperature sensor |
When the condition of the final
judgment is satisfied after satisfying
that of the provisional
judgment:
|
A/T fluid temperature sensor |
DTC CONFIRMATION PROCEDURE
CAUTION: Always drive vehicle at a safe speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK A/T FLUID TEMPERATURE SENSOR FUNCTION
With CONSULT
CAUTION: Never start the engine.
With GST
Is the temperature calculated by subtracting engine coolant temperature from A/T fluid temperature more than 38C (100.4F) or is it less than −27C (−16.6F)? (With CONSULT)/Is "P0711" detected? (With GST)
YES >> Go to TM, "Diagnosis Procedure".
NO-1 [With CONSULT: "FLUID TEMP" is 15C (59F) or more]>>INSPECTION END
NO-2 [With CONSULT: "FLUID TEMP" is 14C (57.2F) or less]>>GO TO 3.
NO-3 (With GST)>>GO TO 3.
3.CHECK DTC DETECTION
With CONSULT
SLCT LVR POSI : D
VHCL/S SE-AT : 10 km/h (7 MPH) or more
ACCELE POSI : 1.0/8 or more
5. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Cool the engine.
Start the engine and wait for at least 3 minutes.
Drive the vehicle and maintain the following conditions for 21 minutes or more.
Selector lever : D position
Vehicle speed : 10 km/h (7 MPH) or more
Accelerator pedal opening : 1.0/8 or more
Check the DTC.
Is "P0711" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK A/T FLUID TEMPERATURE SENSOR
Is the check result normal?
YES >> Check intermittent incident. Refer to GI "Intermittent Incident".
NO >> Repair or replace the malfunctioning parts.
Component Inspection (A/T Fluid Temperature Sensor)
1.CHECK A/T FLUID TEMPERATURE SENSOR
Measure the resistance between the A/T unit connector terminals.
Is the check result normal?
YES >> INSPECTION END
NO >> There is a malfunction of the A/T fluid temperature sensor. Replace the transaxle assembly. Refer to TM, "Removal and Installation".
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0706 Transmission Range Sensor "A" Circuit Range/Performance The ...
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0712 Transmission Fluid Temperature Sensor "A" Circuit Low Under ...
RearView Monitor (if so equipped)
1. CAMERA button (models with navigation)
WARNING
Failure to follow the warnings and instructions
for proper use of the Rear-
View Monitor system could result in serious
injury or death.
RearView Monitor is a convenience feature
and is not a substitute for proper
backing. Always ...
Starting the engine (models with NISSAN Intelligent Key system)
1. Apply the parking brake.
2. Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The starter is designed not to operate if
the shift lever is in any of the driving
positions.
3. Push the ignition switch to the ON position.
Depress the brake pedal and push the ...