DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P0863 | TCM Communication Circui | An error is detected at the initial CAN diagnosis of TCM. | TCM |
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT
Is "P0863" detected?
YES >> Go to TM "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK INTERMITTENT INCIDNT
Refer to GI "Intermittent Incident".
Is the inspection result normal?
YES >> Replace TCM. Refer to TM "Removal and Installation".
NO >> Repair or replace malfunctioning parts.
Evaporative emission system
EVAPORATIVE EMISSION SYSTEM : System Diagram
EVAPORATIVE EMISSION SYSTEM : System
Description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Camshaft position sensor (PHASE)
Engine speed*1
Piston ...
C1145, C1146 Yaw rate/side/decel g
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF DIAGNOSTIC RESULT
With CONSULT.
Turn ignition switch OFF to ON.
Perform self diagnostic result.
Is DTC C1145 or C1146 detected?
YES >> Proceed to diagnosis procedure. Refer to BRC "Diagn ...