Check the fluid level in the reservoir.
The fluid level should be checked when the fluid is cold at fluid temperatures of 32 to 86ºF (0 to 30ºC). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid level should be between the MAX A and MIN B lines.
If the fluid is below the MIN B line, add Genuine NISSAN E-PSF or equivalent. Remove the cap and fill through the opening.
WARNING
Power steering fluid is poisonous and should be stored carefully in marked containers out of the reach of children.
CAUTION
When checking or replacement of automatic transmission fluid is required, it is recommended that you visit a NISSAN dealer for servicing. WARNING When the engine is running, keep hands, jewel ...
For additional information on brake fluid specification, refer to "Recommended fluids/lubricants and capacities" in the "Technical and consumer information" section of this manual. WARNING Use ...
Water outlet
Exploded View
M/T models
1. Engine coolant temperature sensor 2. Clamp 3. Gasket
4. Clamp 5. Bracket 6. Clamp
7. Water outlet 8. Clamp 9. Clamp
10. Cylinder block heater (Canada) A. From electric throttle control actuator B.
To radiator
C. From heater core D. To heater core E. To electric ...
Air pressure monitor
AIR PRESSURE MONITOR : CONSULT Function
(BCM - AIR PRESSURE MONITOR)
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS transmitter IDs
Display tire pressure ...