Nissan Versa

 Sedan Service Manual

Driver controls » Interior lighting system (INL) » Precautions
Precaution for Work

• When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth.
• When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a shop cloth or vinyl tape to protect it.
• Protect the removed parts with a shop cloth and prevent them from being dropped.
• Replace a deformed or damaged clip.
• If a part is specified as a non-reusable part, always replace it with a new one.
• Be sure to tighten bolts and nuts securely to the specified torque.
• After installation is complete, be sure to check that each part works properly.
• Follow the steps below to clean components:

- Water soluble dirt:

• Dip a soft cloth into lukewarm water, wring the water out of the cloth and wipe the dirty area.
• Then rub with a soft, dry cloth.

- Oily dirt:

• Dip a soft cloth into lukewarm water with mild detergent (concentration: within 2 to 3%) and wipe the dirty area.
• Then dip a cloth into fresh water, wring the water out of the cloth and wipe the detergent off.
• Then rub with a soft, dry cloth.

- Do not use organic solvent such as thinner, benzene, alcohol or gasoline.

- For genuine leather seats, use a genuine leather seat cleaner.

PREPARATION

Special Service Tool

The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

SYSTEM DESCRIPTION

COMPONENT PARTS

INTERIOR ROOM LAMP CONTROL SYSTEM

INTERIOR ROOM LAMP CONTROL SYSTEM : Component Parts Location

1. BCM (view with instrument panel removed) 2. Key switch (without Intelligent Key) 3. Push-button ignition switch (with Intelligent Key) 4. Map lamp (if equipped) 5. Interior room lamp 6. Trunk room lamp 7. Trunk lid lock assembly (with Intelligent Key) Trunk lid switch (without Intelligent Key) 8. Front door lock key cylinder switch LH 9. Front door switch LH (RH similar) 10. Rear door switch LH (RH similar) 11. Main power window and door lock/unlock switch 12. Power window and door lock/unlock switch RH

INTERIOR ROOM LAMP CONTROL SYSTEM : Component Description

ILLUMINATION CONTROL SYSTEM

ILLUMINATION CONTROL SYSTEM : Component Parts Location

1. BCM (located behind left side of instrument panel) 2. Combination switch (lighting and turn signal switch) 3. Combination meter (illumination control switch) 4. IPDM E/R

ILLUMINATION CONTROL SYSTEM : Component Description

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

Precaution for Work