Toyota
Nissan Versa
 Sedan Service Manual
Electrical & power control » Power control system (PCS)
Push-button ignition switch

Removal and Installation

REMOVAL

1. Remove NATS antenna amp. Refer to SEC "Removal and Installation".

2. Release the push-button ignition switch pawls and remove the push-button ignition switch (1).

Pawl

REMOVAL

INSTALLATION

Install in the reverse order of removal.

    More about «Power control system (PCS)»:

    Precautions

    System

    Diagnosis system (IPDM E/R)

    IPDM E/R (Intelligent power distribution module engine room)

    U1000 CAN Comm circuit

    B2098 Ignition relay on stuck

    B2099 Ignition relay off stuck

    Power supply and ground circuit

    IPDM E/R

    Precautions

    System

    Diagnosis system (IPDM E/R)

    IPDM E/R (Intelligent power distribution module engine room)

    U1000 CAN Comm circuit

    B2098 Ignition relay on stuck

    B2099 Ignition relay off stuck

    Power supply and ground circuit

    IPDM E/R

    Precautions

    Power distribution system

    Diagnosis and repair work flow

    U1000 CAN Comm circuit

    B2614 ACC Relay circuit

    B2615 Blower relay circuit

    B2616 Ignition relay circuit

    B2618 BCM

    B261A Push-button ignition switch

    B26F1 Ignition relay

    B26F2 Ignition relay

    B26F6 BCM

    Push-button ignition switch

    Push-button ignition switch does not operate

    Push-button ignition switch

    Nissan Versa Sedan Service Manual / Electrical & power control / Power control system (PCS) / Push-button ignition switch

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com